How To Install LYSAGHT NOVALINE® fascia

This page contains information on the installation of LYSAGHT NOVALINE® fascia.

Please be aware that installation of fascia and guttering must be carried out by licensed tradespeople in some Australian states.

Fascia Installation Procedure

Support Spacings

The LYSAGHT NOVALINE® fascia should be supported on rafter clips at 1200mm (maximum centres). The LYSAGHT NOVALINE® fascia should not be used as an end span support.

Use a minimum of two (2) fasteners (Hex Head screws; self drilling screw for steel, or Type 17 for timber) into the pre-punched holes & slots to secure to the rafter. If slots are used then additional fasteners may be required.

STEP 1 Attach rafter clip at each end of the run, then run a string line from end to end of the run. Attach one or two rafter brackets at midregion of the run, level and in line with the string line.
STEP 2 Hook the fascia horizontally under each end clip, then flip the fascia forward and lever over the top of the bracket into the vertical position.
STEP 3 Adjust the fascia to the correct position by sliding it along the brackets, then secure the remainder of the intermediate brackets by twisting into fascia first, and then connecting to the rafters. (Notching, holing or distortion of the NOVALINE® fascia is not recommended.)
STEP 4 Fit the fascia accessories as required. (i.e. Corners, End closers, etc.)

For information on gutter installation see our page: Install LYSAGHT® Gutters to LYSAGHT NOVALINE® Fascia System