LYSAGHT PANELRIB®

Product Description and Features

LYSAGHT PANELRIB® has a fluted profile making it suitable for many applications where flat sheet would not normally be considered.  The longitudinal flutes provide rigidity along the length of the sheet while retaining full flexibility across the width.

• Can be used on exterior and interior walls and on straight or curved surfaces with flutes horizontal or vertical
• Long, straight lengths minimise fixing costs
• Available in a wide variety of COLORBOND® steel colours and ZINCALUME® steel

Note:

• LYSAGHT PANELRIB® is only suitable in for use for walling in non-cyclonic areas
• Only suitable in non-cyclonic areas
• If end laps are necessary because of very long runs, allow at least 75mm lap - a suitable seal is required for external conditions
• Read our Guidelines for using COLORBOND® steel & ZINCALUME® steel.

This search will find the ten closest suppliers for the location you enter, for the selected product. Fill in each of the fields below, then click "SEARCH"

Please note this locator only contains suppliers in AUSTRALIA. If you need suppliers in other countries please contact your local BlueScope Steel office.

Fields marked with * are required

Span Tables and Capacity & Load Tables

Span Tables and limit state wind pressure capacity table can be viewed in the LYSAGHT Walling Solutions brochure. Download LYSAGHT® Walling Solutions (886 KB)

This information is suitable for use only in areas where a tropical cyclone is unlikely to occur as defined in AS1170.2-2002.

Lengths

LYSAGHT PANELRIB® is available in custom cut lengths to suit the application requirements. Check with your local supplier on the maximum and minimum available lengths.

Tolerances

Length: +0mm, -15mm
Width: +2mm, -2mm

Material Specification

• ZINCALUME® steel made from zinc-aluminium alloy coated steel complying with AS1397-2001, G550 (550MPa minimum yield stress), AZ150 (150g/m² minimum coating mass)
• COLORBOND® prepainted steel complying with AS/NZS 2728:Type 4, is made from zinc-aluminium alloy coated steel complying with AS1397-2001, G550 (550MPa minimum yield stress), AZ150 (150g/m² minimum coating mass), or
• COLORBOND® prepainted steel complying with AS/NZS 2728:Type 6, is made from stainless steel complying with JIS G 4305, Grade 430 stainless steel, 430SS550. Subject to enquiry
• The base metal thickness is 0.35mm & 0.42mm  (0.48mm subject to enquiry)

Mass (COLORBOND® steel)

• BMT 0.35mm: 3.29 kg/m²
• BMT 0.42mm: 3.90 kg/m²

 

Schematic

 

Disclaimer

Availability

NSW/ ACT	VIC	TAS	QLD	NT	SA	WA
Avail.	Avail.	Avail.	Avail.	Avail.	Avail.	Avail.

Colour Range

LYSAGHT PANELRIB® is available in a limited range of COLORBOND® steel colours and in unpainted ZINCALUME® steel.

Please check with your local supplier regarding specific colour availability for this product.